Price: $22.99
Includes (4) Pads Approx 2″ x 5″ x 3/8″ Thick, Enough Hardware For 3 Bolts Per Pad, 1 Extra Hardware Included
Helps Slushy Wet Snow Get Thrown Out Chute Instead of Dribbling Out / Clogging & Throws Normal Snow Farther
You must drill holes in your snowblower to install these. Instructions Included. Most People Install 2 Bolts Per Pad. If Desired, 3 Can Be Installed With Included Hardware
It’s recommended to use a pad on each impeller fin – If you install only 1 pad for the snow blower, it may unbalance the impeller and cause bearing wear.
Fender washers hold as good as a metal strap and are easier to work with. Metal straps with pre-made holes dictate where the holes need to be drilled which can cause a problem because many impellers have a cross brace on the underside which means you can’t put a bolt there, you’ll have to bolt it in the plate’s next hole over which might not all line up right. With these washers you can put bolts wherever you need.
You must drill holes in your snowblower to install these. Instructions Included. Most People Install 2 Bolts Per Pad. If Desired, 3 Can Be Installed With Included Hardware
Kit reduces the existing “gap” between the snow blower’s impeller blades and the impeller chamber wall.
Smaller the gap, the greater your machine’s operational efficiency and snow throwing capability will be, and the less likely that your machine will clog up with snow.
Price: $22.99
