Price: $383.99 - $314.00
Still based on open-source Grbl v1.1, the 3018-PROVer V2 CNC has stepped up to more powerful but silent Toshiba TB6S109 drivers with 32-bit chips. More extended function ports were added, such as the 3 Pin Laser Port, Air Assistance Pump Port, and MPG Port. It also supports updating the firmware through an SD card.
The redesigned Z Axis Carriage has fixed excess movement which came from the old design anti-backlash spring. Not only did this improve the engraving accuracy, but also increased the effective range of the Z Axis from 35mm to 40mm. All stepper motors are equipped with manual jog wheels making it easy to adjust and position your spindle or stock material.
The redesigned Z Axis Carriage has fixed excess movement which came from the old design anti-backlash spring. Not only did this improve the engraving accuracy, but also increased the effective range of the Z Axis from 35mm to 40mm. All stepper motors are equipped with manual jog wheels making it easy to adjust and position your spindle or stock material.
This MPG handwheel controller can manually control the XYZ-Axis to run on Gemitsu CNC Router 3018-PROVer V2. Easy to use, no driver needed. Just connect it on the controller board of the CNC router machine, then it works. The running speed is divided into 3 gears: X1 X10 X100; You can also manually control the running speed by adjusting the hand wheel turning speed.
Price: $383.99 - $314.00
